â

By; AvTek

On/off switch 3/8’ hole and RED Blinking Led ¼” hole is mounted in a convenient location…

allowing you to see if/when lights are on during the day. Led is pushed into the lens from the back-side.

SeaLitez, was cleverly Engineered & Designed to be installed in the “Back-Eddy’s” of your transom. Therefore NO forces are created to dislodge SeaLitez from it’s mounting.

No large thru-hull holes are drilled. In fact NO holes at all should be drilled thru your hull.

1^st Step; place tape on drill-bit 3/32” as a guide to stop drilling

2^nd and proceeding steps are as follows:

Measure 12 to 15 inches below water-line & mark locations for two drill holes.

Note the suction cups, they help hold the housing during install, and they stick like glue.

Drill ONLY TWO holes. Stop drilling at marked tape

Moisten the two suction cups, then screw-in s/s screws, use caution DO-NOT over-tighten. Screws or plastic will break. Cover screws with water sealant. After both screws are tighten, grasp housing and firmly twist…ensuring that your mounting was successful.

Ground wires (all black) connected to the Neg. battery post.

Sea-Litez® is a REGISTERED Trade mark of AvTek.

It's Name and Product is Protected by Law. Any Reuse

Packaging, or Distribution is Prohibited by Law, Unless Express Written Permission is Granted by the Manufacture. (253) 813-1455

QUALITY PRODUCTS SINCE 1983

MANUFACTURED BY: AvTek 253/813-1455

PROUDLY MADE 25230- 45TH Ave. SO.

IN THE USA Kent, WA. 98032