Electrical  while VFR are a Nuisance,

While IFR They're DANGEROUS.

Meets Coast-Guard-Approval, SOLD and used by Boaters for years to detect: Electrical/Alternator Failures and low oil pressure.  NOT zero oil pressure but 12 pounds. When oil pressure in your engine reaches 12 pounds a RED-Led Blinks, allows you to save your Expensive Engine.

However pilots believe that Electrical, will NEVER Fail.  GET 1^ST  Alert Today  to detect Elect Failures time and make it down safely.

AvTek has designed a truly EARLY warning detection system that is: Simple, Flawless, and Absolutely Reliable (NO FALSE ALARMS). Called:  1st Alert

1st Alert  will detect:   * Alternator Failure * Broken or slipping Belts * Leaky Diodes * Regulator failure and Dangerous Low Oil and Vacuum Pressure

* Detects if you forgot to turn OFF the Master Switch, after tie down.

AvTek has designed 1st Alert using a TEXAS INSTRUMENTâ    Reliable MicroCircuit. 1st Alert will NEVER need repair.

PULSING RED L.E.D, by Kingbrightâ  

        1st Alert Now Plugs into Cig Lighter, NO install

                 $159.95

Red Led is brighter then normal LED's, will Alert you at the 1^ST sign of Trouble.

1^ST Alert looks for reverse current from the ship’s battery, which is the 1^ST indication that the charging system has problems. Very reliable.  At 1.5 oz 1st Alert Installs quickly.

1^ST Alert will begin to pulse each, and every-time you 1st turn-on the Master Switch as you hit the starter "KEY or Button" .   Then as the Alternator/Generator comes on, 1^ST Alert's RED Pulsing Led will go OUT.  This is your reassurance everything is O.K. before you depart. 1^ST Alert is now Armed and ready to detect any In-Flight Electrical Problems.

1^ST Alert will also Intermittently Pulse when you have: Leaky Diodes, previously very difficult for Mechanic's too locate.  Diodes and Field/Stator winding problems are all difficult to trouble shoot.

1^ST Alert will detect them all: Each time, every time; Immediately, and Instantly.

1^ST Alert will also remind you that the Master-Switch is still ON, before you drive home.

1^ST Alert Plugs into your Cig-Lighter No installs, or connect two wires with a screw-driver in 40 minutes .

1^ST Alert will detect OVER-VOLTAGE  here's how:

Over-Voltage Problems, are very rare! But, can happen when the Alternator windings malfunction.  When this does happen...the VOLTAGE will increase so fast (Instantly) that the Alternator goes into "OVERDRIVE" and the Voltage/Amperage increases to the point YOUR Panel Circuit Breakers will open, and soon low buss voltage.

Under Voltage by Far occurs more often then Over Voltage. Belt, wire, diodes, corrosion the list is very long of what makes Under Voltage.  Then...a DEAD Panel will soon occur.  So AvTek Chose this environment (Under Voltage) to Alert YOU!

1^STAlert Tells you it is LOW Voltage and LOW will soon mean:  NO VOLTAGE at ALL.

1^STAlert does MORE then detect Low Voltage.  It also detects reverse current from the ships Battery. 

...Your battery is used for about 10 to 30 seconds to start the engine 1^ST Alert will blink during this time. Then the engine starts and the alternator NOW delivery's amperage to replenish what was taken out during the starting process, 1^ST Alert will reset itself and turn-OFF.    The Texas Instrument Chip is Very Smart.

  You can purchase the basic model of 1st Alert to detect only Electrical Failures, or add on: Vacuum and Oil Pressure detections.

                Get the Very Best Protection; Click here 1st_alert_and_stdby_elec_kit.

PANEL MOUNTED LED or, Self-Contained. What's the difference?

Self-Contained, has the Red Led on the Small Box which you would mount under the panel, just above your Knees in sight from the pilots seat.    No Need to drill 1/4" hole in Panel.

(NEW *Great* Products Click Voltmeter & 3-Way Splitter.   Discounted with 1st Alert

1st Alert's Panel Mounted Red Led uses the same Small Box, but the box is located behind the panel.  You see Nothing.  However you must drill a 1/4"  hole in the panel to accommodate the Red Led lens holder.  PLEASE, specify Panel mounted or self-contained when ordering.

IF THIS APPEALS TO YOU...Call AvTek for:

Info 253/813-1455 (Day/Eve) or {24hr. Order 1-800/770-3265}  fax 253/850-7978 Or Submit-Order

                                    Need Your Aircraft Voltage  No Payment requested at this time

  Hey, want some GE Halogen Lights

    PROUDLY MADE at 25230- 45TH Ave. SO. IN THE USA Kent, WA. 98032

                            .....QUALITY PRODUCTS SINCE 1983

    Click Here StdBy Info.           Click Here Back AvTek HomePage     StdBy Elect Is it Worth-it?

         Click Here pulsar. Info        Click Here  ORDER      Click Here AvTek Products        

      Total Elect Failure: Go Here Aircraft Destroyed While IFR You Need to see this...     Click Here email page

           Click here to see AvTek's Service Department         Returning Products For Service page

                                                          Seattle, WA. (West Coast Time)